Related Manuals for PIEPS DSP
Summary of Contents for PIEPS DSP
- Page 1 0 6 / 1 2 MA N U AL P I E P S DS P | P IE P S DS P T OUR P R E M I U M A L P I N E P E R f o R M A N c E...
- Page 2 w w w. p i e p s . c o m...
- Page 3 PIEPS DSP/DSP Tour is not fully functional. Bring with PIEPS DSP/DSP Tour. The basic rules of conduct in case of an emergency – as defined in the your PIEPS DSP/DSP Tour to an authorized service center.
-
Page 4: In Case Of Emergency
IMPORTANT! Ensure that, during search, there are no electronic devices (e.g. mobile phones, PIEPS recommends: • Minimum distance in SEND-mode: 15 cm • Minimum distance in radio equipment etc.) or massive metal items in the immediate vicinity. The fundamental rules for SEARCH-mode: 1,5 m;... -
Page 5: Search Mode
S EA RCH-MO DE COAR SE SEARC H Press the main switch lock and push the main Point of impact As soon as the PIEPS DSP/DSP Tour picks up Number of burials switch to the „SEARCH“ position. Point of disappearance... -
Page 6: Fine S Earch
1 footstep per reading update (depends on the type of buried beacons, approx. 0,5 - 1,3 sec.). Keep the PIEPS DSP/DSP Tour as close as possible to the surface of the snow to have the minimum distance to the transmitting beacon. -
Page 7: Scan Function
The frequency of the strongest (closest) beacon is measured. The deviation from the standardized frequency 457kHz Press the SCAN button while in the SEARCH-mode. The PIEPS DSP will begin scanning the is indicated. The shown number is the deviation in Hz and the entire receiving range. -
Page 8: Software Update
The PIEPS Backup is a mini emergency-transmitter (frequency 457 How can you display your firmware? kHz) that is worn in additional to the PIEPS DSP/DSP Tour directly on the body and only starts to transmit in case of an emergency. So PIEPS... -
Page 9: Wa Rnin G C O De S
DSP; The device conforms to the Standard ETS 300718 WEEE 2002/96/EC Canada: IC: 4710A-DSP01 USA: FCC ID: REMDSP01 This device conforms to Paragraph 15 of the FCC regulations. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. - Page 10 H E R S T E L L E R / M A n U F A C T U R E R PIEPS GmbH, Parkring 4, 8403 Lebring, Austria www.pieps.com...
Need help?
Do you have a question about the DSP and is the answer not in the manual?
Questions and answers