PROEL V10WAVE User Manual page 6

CD / DVD / MP3 players. The MINI JACK is wired as follows:
Tip = positive signal of left channel
Ring = positive signal of right channel
Sleeve = shield or ground
3. CH1 LINE / MP3 SWITCH
Use this switch to select the external player connected to RCA/MINI JACK connectors or the built-in
Media Player as the source for the input channel 1.
4. CH1 LEVEL
This potentiometer sets the level of the respective CH1 LINE input or the built-in Media Player.
5. CH2 / CH3 MIC IN (XLR)
This is a female XLR connector that accepts an XLR plug from any balanced or unbalanced dynamic
microphone or line level device. The XLR input is wired as follows:
Pin 1 = shield or ground
Pin 2 = + positive or "hot"
Pin 3 = - negative or "cold"
6. CH2 / CH3 LINE IN (JACK)
This is a female JACK connector that accepts a JACK plug from any dynamic balanced or unbalanced
microphone or line level device. The balanced JACK input is wired as follows:
Tip = + positive or "hot"
Ring = - negative or "cold"
Sleeve = shield or ground
The unbalanced JACK input is wired as follows:
Tip = + positive or "hot"
Sleeve = shield or ground
7. WIRELESS 1 / 2
These inputs are reserved for the PROEL U24H or U24B 2.4GHz USB Wireless Microphone. WIRELESS 1 is
routed to CH2 and WIRELESS 2 is routed to CH3. NOTE: when using the wireless microphones, it is
preferable to disconnect any MIC/LINE device from the respective channel.
8. CH2 / CH3 LINE/MIC SWITCH
This switch sets the sensitivity of the channel input between microphone level or line level.
9. CH2 / CH3 LEVEL
This potentiometer sets the level of CH2 / CH3 channels and of WIRELESS 1 / 2.
10. EQ LOW
This potentiometer sets the LOW TONE level: if rotated clockwise it enhances the lows, if rotated
counterclockwise it reduces the lows (in the centre position the response is flat).
11. EQ HIGH
This potentiometer sets the HIGH TONE level: if rotated clockwise it enhances the highs, if rotated
counterclockwise it reduces the highs (in the centre position the response is flat).
12. MASTER
This potentiometer sets the general level of all signals send to the internal speaker amplifier.
13. SIGNAL / LIMIT
GREEN LED illuminates when a signal is sent to the amplifier.
RED LED illuminates when the internal amplifier's output is limited. When this LED flashes, reduce the
signal level.
6