Table of Contents
Advertisement
3.
To add other IP cameras:
1)
On the left side of the interface, you can enter the IP address, protocol, management port and other
information of the IP camera to be added.
2)
Click Add to add the camera.
Note:
If you check the Synchronise IP Camera checkbox, the default settings of the NVR for the IP
camera is applied to the added camera.
Configuring Basic Parameters of IP Cameras
After the adding of the IP cameras, the basic information of the camera lists in the page and you can configure the
basic setting of the IP cameras.
Steps:
1.
Click the
icon to edit the parameters; you can edit the IP address, protocol and other parameters.
2.
Click apply to save the settings and click OK to exit the editing interface.
To edit more parameters:
Click the Advance Set icon.
1.
2.
You can edit the network information and the password of the camera.
Click Apply to save the settings and click OK to exit the interface.
3.
Edit
t he
P arameters
Network
C onfiguration
o f
t he
C amera
Advertisement
Table of Contents
