Door Adjustment - U-Line Wine Captain User Manual

User's Manual
Your Wine Captain doors were aligned at the factory before shipment.
Occasional re-adjustment may be necessary. The following procedure
will correct for up to 1/4" alignment.
The door should never be flush with the top of the cabinet.
Even when level, the top edge of the door will be 1/8" below
the top of the cabinet (see Figure 12).
TO ADJUST DOOR:
1. Compare
edge of the door
(opposite the hinges)
to the top edge of the
cabinet and note the
type (up or down) of
adjustment needed.
2. Remove the top hinge pivot pin with a 7/64" hex wrench (see
Figure 13) and lift door off bottom hinge pin. Be careful not to lose
door closer inserts (see Figure 15).
3. With door
inspect the bottom hinge
plate mounting holes.
a. If your plate has slotted
mounting holes, loosen
but do not remove the
two hinge plate screws.
b. If your plate does not
have slotted mounting
holes, remove the old
plate and install the new
plate with the notch to
the inside of the door
(see Figure 14).

DOOR ADJUSTMENT

1/8"
the top
upside-down,
Figure 12
Figure 13
16
DOOR001a
UL310