Opt Lasers ooznest WorkBee Setup Manual page 3

General Laser Safety Warnings and Cautions
Only person with specialized training and appropriate laser safety knowledge
can use and maintain the laser head. The laser head operator must be aware of
laser radiation hazard.
While laser head is operating protection Laser Glasses designed for 190 – 540 nm
(OD 7+) should be used. Make sure that all personnel in the same room worn
protection glasses.
Eye exposure to the direct or diffusely reflected laser beam is a hazard. The laser
head beam may cause permanent eye damage.
Skin exposure to the laser beam is a hazard. The laser beam may cause serious
skin burns. Laser beam may easily burn cloth.
It is possible to get serious injury while using this product or being in the vicinity of
an individual using it. Improper use of the laser head can result in injury or death.
Flammable substances exposure to the laser beam may pose fire hazard. The
laser head operation in an explosive atmosphere may be dangerous. The
working area must be well ventilated. During the operation laser beam may
ignite gases or flammable liquids.
Before making any
maintenance, the laser should be pow ered off and disconnected from the
pow er supply and CNC main board.
The laser head must be properly mounted to a rigid body such that it cannot be
mov ed unintentionally. Unintentional mov e of the laser head is dangerous.
The unauthorized personnel must have no access to the system into which the
laser head is integrated. The laser head must be stored out of the reach of
children. Untrained persons are not allowed to operate, maintain and observe
operation of the laser head.
Specular reflection materials should not be placed in front of operating lasers
head. Remember, diffused reflection of the laser beam is uncontrolled and may
pose hazard to eye.
Appropriate shielding should be used around the system into w hich the laser
head is integrated. The system in w hich laser head is used must be equipped
w ith key sw itch and safety interlock.
Responsibility of use or misuse belongs to the end user. Tomorrow 's System and its
affiliates accept no responsibility for use or misuse by the user. I f you may not be able
to use this product properly, w e recommend that you do not begin use or cease use
immediately.
Included Parts
Parts included in the Opt Lasers Ooznest Workbee Laser Upgrade kit. All needed screws are also
included in the kit.
WorkBee La s er Upgra de Setup Gui de
adjustments, changing
4 / 25
accessories or performing