Notes For Installation; Installing Water Filtration System - LG WHD71RW4RP Owner's Manual

Notes for Installation

• Keep the clearance of over 10 cm between
all sides (rear, right and left sides) of the
appliance and the wall for proper ventilation.
Failure to do so may cause malfunctions.
• When connecting the water hose, do not
connect it to the hot water tap. Doing so may
cause malfunctions.
• Check the pipe and hose connection for
leaks. Water can leak and cause electric
shock or injury.
• When transporting the appliance, do not tilt
the appliance over 30 degrees. Doing so
may cause malfunctions.
• Install the appliance inside with a
surrounding temperature of over 5 °C and
less than 43 °C. Failure to do so may cause
malfunctions.
• Connect the appliance to a drinking water
tap with a water pressure of 35 - 860 kPa.
Failure to do so may cause malfunctions.
• Water should pass through the hot water
tank pipe, and this pipe should be left open.
• A spring-type safety valve for reducing
pressure is installed on the piping of hot
water tank of this appliance.
• Install the pipe so that the safety valve is
connected toward the bottom in a
nonfreezing environment.
• After installation, dispense the cold, hot and
ambient water for about 10 minutes before
using it.
• When installing the appliance, avoid the
location close to a toilet or in front of an air
conditioner.
• Connect the power supply cord (or plug) to
the socket outlet. Don't double up with other
appliances on the same outlet.
• After installing the appliance, connect the
power plug into a socket outlet. Before
moving and discarding the appliance,
disconnect the plug from the socket outlet.
If the Socket Outlet Has a Ground Terminal
• If the socket outlet has a ground terminal, no
additional grounding is required.
If there is No Grounding Terminal
• Check if the circuit breaker is installed. If not,
ask a special technician to install it before
using the appliance.
Installing water filtration
system
1
Connect the white and blue hose as shown
below.
• Connect the white (water supply) hose to
tap water.
• Install the blue (drain) hose on the sink.
2
Connect the power plug to an appropriate
socket.
3
Open the water supply valve.
4
After two hours, dispense water inside the
appliance for about 10 minutes.
EN
white hose
blue hose
11