Error Message - Spektrum SMART Technology SPMXC1040 User Manual

EN
5. During the charging process, the 4-digit LED will display battery voltage, charging
current, and charging capacity.
Battery voltage
Voltage of
LiPo battery
Voltage of
LiHV battery
6. The LED will stay red during the charging process.
7. Press and hold the dial for 3 seconds during charging process to stop
charging. The LED will turn off.
8. When the charging process is fi nished, the status LED will turn green,
blink 5 times, and emit an audible sound. The status LED stays green
and the 4-digit LED will display "FULL".
9. Remove the battery from the charger. After 30 seconds, the 4-digit
LED will display "LIPO" indicating the charger is ready for another charge process.

Error Message

In the event of an error, the status LED will blink red and beep twice per second. After ten
blinks the status LED will remain red and the 4-digit LED will display one of the following
error codes:
The battery has a dead cell or the voltage of a cell is too high or too low
for safe charging.
The battery polarity is connected incorrectly.
The battery connection is broken.
A short circuit or over current is detected.
The DC input voltage is too high or too low.
6
Charging current (A)
Charging current
Charging capacity
Charging capacity (mAh)