Charging Procedures; Operation - Spektrum SMART Technology SPMXC1040 User Manual

Charging Procedures

Using the AC power Source
When the charger is powered on, the four status LEDs will simultaneously blink and beep
one time. The 4-digit LED displays will read LIPO to indicate the charger is ready to accept
batteries. You can toggle between LiPo and LiHV charging with the rotary dial at this time.
NOTICE: Each charging port can only charge one battery at a time.

Operation

1. Paying attention to proper polarity, insert the battery lead into
the appropriate connector slot on the charger (Molex, JST,
UM, PH2.0).
2. Rotate the dial to select the battery type (LiPo/LiHV). Press
the dial once to confi rm.
LiPo battery
3. Rotate the dial to select charging current (0.05–1.2A).
NOTICE: Charging current cannot be changed during the charge process. Always
confi rm the charging current is appropriate for your battery before starting to charge.
Charging current (A)
4. Press and hold the dial for 3 seconds to start charging process.
The related status LED will turn red and the charger will emit a long beep.
AC 100-240V
LiHV battery
+ –
Charging current (A)
Using a DC power supply
+ –
12V
DC 11-15V
Press the dial once
to confi rm the
battery type.
EN
5