Intercom - Panasonic KX-TGF880 Series Operating Instructions Manual

Intercom

Intercom calls can be made:
– between handsets
– between a handset and the base unit
Note:
R When paging unit(s), the paged unit(s) beeps
for 1 minute.
R If you receive an outside call while talking on the
intercom, the interrupt tone sounds (page 48).
– Handset: To finish intercom, press MOFFN.
To answer the call, press M
– Base unit: To finish intercom, place the
corded handset on the cradle. If the
speakerphone is used, press MZN. To answer
the call, lift the corded handset. If the
speakerphone is used, press MZN.
R To change the handset ringer volume and ringer
tone for intercom, see page 48.
Making an intercom call
Handset
1
MMENUN a MbN: "Intercom" a MSELECTN
2
MbN: Select the desired unit or "Voice
paging". a MSELECTN
R If you select "Voice paging", speak into
the microphone after the beep. Your voice
will be heard using the speakers of the base
unit and all handsets, until a paged party
answers your page or until you press MOFFN.
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press MOFFN.
Note:
R You can also use the MINTERCOMN soft key, if
displayed, to make intercom calls.
R You cannot use voice paging if other units are in
use.
Base unit
1
Press MINTERCOMN.
When 2 or more handsets are registered:
MbN: Select the desired unit. a MSELECTN
R To page all handsets, press 0 or wait for a
few seconds.
R Lift the corded handset if needed.
2
When you finish talking, press MZN or place
the corded handset on the cradle.
For assistance, please visit http://shop.panasonic.com/support
TGF88x(en)_1104_ver033.pdf 31
Answering an intercom call
Handset
1
Press M
2
When you finish talking, press MOFFN.
Base unit
1
Press MZN or lift the corded handset to answer
the page.
2
When you finish talking, press MZN or place
the corded handset on the cradle.
N.
Turning auto intercom on/off
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press M
corded handset, or press MZN. When this feature
is set to "On", the monitoring handset or base unit
for the baby monitor feature (page 55) will also
answer baby monitor calls automatically. The
default setting is "Off".
Handset / Base unit
1
MMENUN#273
2
MbN: Select the desired setting. a MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned on.
Intercom
N to answer the page.
N, lift the
2019/11/05
31
13:22:53