Link To Cell; Link To Cell Feature; Pairing A Cellular Phone - Panasonic KX-TGF880 Series Operating Instructions Manual

Link to cell feature

You can connect your base unit and cellular phone
using Bluetooth wireless technology, so that you
can make or answer cellular calls using your
phone system. This allows you to:
– use the unit to talk on cellular calls even if some
areas of your home have poor cellular
reception, simply by placing your cellular phone
in an area with good reception.
– talk on cellular calls even if your cellular phone
is in your pocket or bag.
– enjoy cordless cellular calls even if your cellular
phone plugged in and charging.
Important:
R Your cellular phone must support the Hands
Free Profile (HFP) specification.
R You may pair 2 cellular phones and 1 Bluetooth
headset.
R The unit cannot be used to talk on 2 cellular
lines at the same time.
R Only 1 Bluetooth device can be used with the
*1
unit at a time .
R Locate your cellular phone near the base unit. If
the cellular phone is too close to the base unit
during a cellular call, you may hear noise. For
best performance, we recommend placing the
cellular phone between 0.6 m to 3 m (2 feet to
10 feet) away from the base unit.
*1 You cannot use a Bluetooth headset to talk on
a cellular line.

Pairing a cellular phone

Important:
R For more details and the list of compatible
cellular phones, please visit our Web site:
http://shop.panasonic.com/bluetooth-phone
R Before pairing a Bluetooth enabled cellular
phone to the base unit, make sure that no other
Bluetooth device such as a Bluetooth headset is
connected to your cellular phone.
1
Base unit:
Press and hold MCELL 1N or MCELL 2N for
about 5 seconds.
R After the corresponding CELL indicator on
the base unit starts flashing, the rest of the
procedure must be completed within 5
minutes.
For assistance, please visit http://shop.panasonic.com/support
TGF88x(en)_1104_ver033.pdf 17
2
Your cellular phone:
While the corresponding CELL indicator is
flashing, follow the instructions of your cellular
phone to enter the pairing mode.
R Depending on your cellular phone, it may
ask you to enter the Bluetooth PIN (default:
"0000"). If your cellular phone shows
PassKey confirmation on its display, follow
the directions to proceed.
3
Base unit:
Wait until a long beep sounds.
R It may take more than 10 seconds to
complete pairing.
R When the corresponding CELL indicator
lights up, the cellular phone is connected to
the base unit. You are ready to make
cellular calls.
Note:
R If the cellular phone has already paired to the
base unit, its pairing is overwritten.
R Make sure that your cellular phone is set to
connect to this product automatically. Refer to
your cellular phone's operating instructions.
R Make sure you cancel your cellular phone's
current pairing if you want to pair it to the other
line (page 17).
R The default setting for the alert feature is "On",
so when you pair your cellular phone to the
base unit, this feature may be activated
(page 62). (This depends on the version and
type of cellular phone you are using.)
Unpairing a cellular phone
You can cancel the pairing of a cellular phone that
is stored in the base unit.
Handset / Base unit
1
For CELL 1: MMENUN#6111
For CELL 2: MMENUN#6112
2
MbN: "Yes" a MSELECTN
R When the cellular phone is unpaired, the
CELL indicator is turned off.
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN

Link to Cell

17
2019/11/05 13:22:53