Answer By Voice Command - Panasonic KX-TGF880 Series Operating Instructions Manual

Answer by Voice Command

Answer by voice command
This feature allows you to answer incoming calls
automatically with your voice. When your voice is
detected, answered calls will automatically be
directed to the speakerphone mode. The default
setting is "Off".
Important:
R Before using this feature, we recommend that
you test it and adjust the voice command
sensitivity as needed.
R For best performance, answer the call within a
range of 50 cm (20 inches) to 1 m (40 inches).
R Once this feature is turned on, the Talking
Caller ID will be activated automatically. To turn
off the Talking Caller ID feature, see page 48.
R Ambient noise (dog barking, TV sound, etc.)
may cause the unit to answer an incoming call.
R When this feature is used, the unit disconnects
the call automatically after 3 minutes. You may
hear a warning tone and the unit may prompt
you to press * to continue talking 1 minute
before disconnecting.
R Once you press any key during a call, the call is
continued.
Note:
R When a call is manually answered using a unit,
voice detection will end, and the answer by
voice command feature stops operating.
R This feature is not available while baby monitor
is set to "On" (page 53).
R The configured settings are common for all lines
(landline and cellular lines).
Turning answer by voice command on/off
Handset
1
Press and hold * for about 2 seconds.
2
MbN: Select the desired setting. a MSAVEN
R If you selected "Off", go to step 4 to exit.
3
MYESN a The unit will display and announce
the voice command guidance.
R We recommend answering calls as
demonstrated.
R There must be a 1 second pause between
the two phrases.
4
To stop: Press MSTOPN.
To playback: Press MYESN.
To exit: Press MOFFN.
30 For assistance, please visit http://shop.panasonic.com/support
TGF88x(en)_1104_ver033.pdf 30
Note:
R If you wish to turn on answer by voice command
feature, select "Tone 1" to "Tone 5" as your
ringer tone (page 46, 48). If another ringer
tone is selected, the unit will automatically use
the default ringer tones (Landline: "Tone 1",
CELL 1: "Tone 2", CELL 2: "Tone 4").
Answer by voice command sensitivity
You can adjust the sensitivity of the answer by
voice command. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
Handset
1
MMENUN#107
2
MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering calls
Handset / Base unit
1
When the unit rings, speak clearly as
demonstrated by the voice guidance. Refer to
step 3, "Turning answer by voice command on/
off", page 30.
2
When you finish talking, press MOFFN on the
handset or MZN on the base unit.
Note for base unit:
R In step 1, you need to answer a call while the
base unit is not ringing or not announcing caller
information.
2019/11/05 13:22:53