Engine Identification; Prior To Starting; Check - Oil Level - NTC RZ 122 Operation Manual

Asphalt and concrete cutters Operation manual

2.4. Engine Identification

In case of problems related to the engine report
Fir. Location of the S/N on engine HONDA
also engine type and serial number. This number
is stamped on the engine block (HONDA) If you
have doubts, contact the manufacturer.
In case of warranty claims, contact your local
Honda distributor.

3. PRIOR TO STARTING

- Check whether the engine leaking (leaks) oil. In case of defect, contact an authorized service
center or manufacturer.
- Bolted connections for loop control of depth of cut and the matrix arm guidance (SS 120, 170) are
glued. Screws at the pulleys, the drive chassis are tight and prescribed the query moment. We
therefore recommend against any potential activity associated with permitting and tightening of
joints, and contact information to an authorized service center or manufacturer.

3.1. Check - Oil Level

It is highly recommended to check regularly the
engine oil level even at machines equipped with
the oil sensor.
In case of a machine without the oil sensor,
daily check is a must.
NOTE :
Operation with insufficient oil level may cause
serious damage to the engine.
Check the engine oil level daily!
Oil level check:
Place the machine in horizontal position.
Unsrew the plug from the check / filling hole on
the engine. If the oil level is correct, the oil
flows out slightly.
page 12 issued