Advertisement
5. mAintenAnce
WArninG! make sure battery is removed before carrying out any maintenance.
‰
5.1.
Always store the polisher on its side so that the foam pad does not become compressed and/or distorted.
5.2.
remove bonnet when not in use to allow foam pad to dry out.
5.3.
clean the bonnet regularly by hand washing with soap and water.
do not immerse the foam pad in water. Washing the bonnet is sufficient.
8
5.4.
to remove the foam pad, proceed as follows:
5.4.1.
remove the bonnet.
5.4.2.
insert a rod (cross headed screwdriver or similar) into the hole in the side of the pad mounting, see fig.1.
5.4.3.
rotate the pad until the rod contacts the counter-weight.
5.4.4.
Hold the pad with one hand.
5.4.5.
undo the motor shaft using a slotted screwdriver. it has a reversed thread, turn it clockwise to undo it and anti-clockwise to
tighten it, see fig.2. fit a new pad, assembly is reverse of the above.
Fig.1
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Waste electrical and electronic equipment (Weee). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
importAnt: no liability is accepted for incorrect use of this product.
WArrAntY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
dispose of this product at the end of its working life in compliance with the eu directive on
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
Fig.2
environmental protection
Weee regulations
Battery removal
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
cP2518l | issue 1 25/11/16
Advertisement
