Advertisement
4. OPERATING INSTRUCTIONS
4.1
After completing steps in section 3 make sure that the sander is at the lowest speed setting and plug it
into the mains power supply.
4.2
Hold in the trigger safety lock in and squeeze the trigger (fig.3B), adjust the speed with the scroll switch
(fig.3E)
4.3
When finished release the trigger to stop the sander,
4.4
To change sanding belt, push the lever (fig.2B, fig.3D) forward, this will shorten the length of the arm
and loosen the sanding belt. Slide the old belt off and replace with the same size belt. Pull the lever
(fig.2B, fig.3D) back to tighten the belt. To change the arm and belt repeat from 3.1 "PREPARING FOR
USE"
5. MAINTENANCE
WARNING! Disconnect
performing maintenance. Replace or repair damaged parts. Use recommended parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1
Clean the underside of the sander after use. Use an air line to blow dust out from around the motor by
passing the air through the ventilation holes.
5.2
Change belts when required.
5.3
Check brushes after every 200 hours of use. To do so remove the screws at end of the motor cover and
remove the tip of the cover (fig.3A), remove the brass brush holder electrical connection, remove the
brush holder and examine the carbon bush. Change brushes when they are only 5mm in length. Ensure
the unit is correctly re-assembled.
5.4
All other service and maintenance must be carried out by an authorised service agent.
5.5
When not in use store in a safe, dry, childproof location.
Declaration of Conformity
Belt Sander
Model: SBS35
2004/108/EC EMC Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
93/68/EEC CE Marking Directive
2006/95/EC Low Voltage Directive
2006/42/EC Machinery Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice. IMPORTANT: No liability is accepted for incorrect use of this equipment. WARRANTY: Guarantee is 12 months from
purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on
01284 757525 and leave your full name and address, including postcode.
sander
from mains power supply before changing accessories, servicing or
We, the sole importer into the UK, declare that the product listed here is in conformity with the following
standards and directives.
The construction file for this products are held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
fig.3
21st April 2008
01284 757500
W e b
01284 703534
email
SBS35
www.sealey.co.uk
sales@sealey.co.uk
Issue No: 1 - 21/04/08
Advertisement
