Sealey CP108VSPBO Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions protection
1. SAFETY
9
Maintain the tool and battery in good condition. Check moving parts alignment on a regular basis.
9
Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
Ensure the tool is switched off before installing the battery pack.
9
Keep the tool and charger clean for best and safest performance.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
9
Evaluate your working area before using the tool; e.g. ceilings, floors and enclosures may contain electrical items or water piping.
9
Ensure battery pack is correctly inserted into the handle and latched in place before attempting to switch on tool.
9
Secure loose work pieces with a clamp, vice or other adequate holding device.
9
9
Avoid unintentional starting.
Wear approved safety eye protection (standard spectacles are not adequate).
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-skid shoes.
9
Keep children and unauthorised persons away from the working area.
9
Perform formal risk assessment before use.
9
DO NOT use the tool where there are flammable liquids, solids or gases, such as paint solvents, etc.
8
8
DO NOT allow children to operate the tool.
DO NOT operate the tool if any parts are missing as this may cause failure and/or personal injury.
8
8
DO NOT hold unsecured work piece in your hand.
8
DO NOT leave the tool operating unattended.
DO NOT carry the tool with your finger on the power switch. Keep chuck direction switch in the locked position.
8
DO NOT use the tool for a task it is not designed to perform.
8
DO NOT use accessories which are not designed or recommended for this tool
8
8
DO NOT use excessively oversized disc paper.
DO NOT operate the tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT get the tool, battery or battery charger wet or use in damp or wet locations.
8
2. INTRODUCTION
Part of the SV10.8 Series offering a one battery fits all solution, keeping costs down without compromising on performance. Compact,
lightweight cordless sander/polisher - body only. Comfortable housing with soft grip to help reduce vibration. Variable 6 speed control with
no-load speeds ranging from 2500 to 5000rpm. Supplied with Backing pad. Suitable for hook and loop sanding and polishing pads. Requires
compatible 10.8V 2Ah or 4Ah battery and mains charger, sold separately.
3. SPECIFICATION
MODEL NO.: ................................................... CP108VSPBO
Battery: ............... 10.8V 2Ah - 4Ah Lithium-ion (not included)
No-Load Speeds: .................................................. 2500-5000
Pad Size: ................................................................... 150mm
Noise Power/Pressure: .................................. 65.5/54.5dB(A)
Accessories (not included):
Battery: .........................................................CP108VBP 2Ah
Battery: .........................................................CP108VBP 4Ah
Mains charger: ................................................... CP108VMC
4. OPERATION
NOTE: Battery state is indicated by the three LEDs on handle (fig.1).
NOTE: Test polisher, speed setting, polishing sponge/mop and medium
being worked on a small, obscure area before applying to item be worked.
© Jack Sealey Limited
10.8V SV10.8 SERIES Ø150MM DUAL ACTION
SANDER/POLISHER - BODY ONLY
MODEL NO:
Wear safety
Wear protective
footwear
gloves
Original Language Version
CP108VSPBO
Wear protective Wear ear
clothing protection
On/Off Switch
Fig. 1
Wear a mask
Speed Control
Battery Indicator
CP108VSPBO Issue 1 06/06/22