SC&T VDKM02B Quick Manual

1 4
2 5
3 6
1. ON (Green)
On – Device ready
Flashing – System starting up
2. LINK (Blue)
On– Link connected
Flashing- Trying to connect/ no input
3. IR (Red)
On – Receive IR signal
Button Instruction:
Button -
Short Press *Reduce Number
Press together
Reduce Number: switches channel or function number down
Increase Number: switches channel or function number up
Trouble Shooting

HDCP fail: Please use the receiver remote or front panel and enable
Menu 49 "HDCP always On" function on the receiver box.
(Press: Menu -> 49 -> Enter -> 1 -> Enter)

No display: Please force 1080p 60 Hz output on the receiver box by
pressing "Menus -> 41 -> Enter -> 3-> Enter" on the receiver remote
or front panel.

Make sure the Transmitter & Receiver are on the same Channel

Reset to Default: Menu -> 333 -> Enter
VDKM02B: Quick Guide
4. DVI(Green)
Transmitter: Video input from DVI
Receiver: Video output to DVI
5. VGA(Blue)
Transmitter: Video input from VGA
Receiver: Video output to VGA
6. MSG (Red)
On – Receive "Remote" Signal
Flashing- System warring
+ Menu
*Increase Number
Menu/Cancel
Enter
Point to Point Application
Step 1. Setup the Remote
Note: This remote can only control either Tx or Rx.
This Process only sets up the remotes.
You don't have to point the remote to the devices.
Transmitter (Tx)
○
○
7 at the same time
Press Φ &
*MSG light will light when receive remote signal
Step 2. Plug and Use
If there are multiple systems on the same network, please make sure each
pair is on a different channel. *Default Channel "0"
Receiver (Rx)
○
8 at the same time
○
Press Φ &