Advertisement
4.2.7.
Having replaced the vehicle battery and reconnected it, switch the memory safe off by pressing the on/off switch for a further
3 seconds. Disconnect the lead from the vehicle.
NOTE: The unit will close down after 4 hours to save power. All six LEDs will light for 30 seconds as a warning; to re-energise, press
the on/off button again for 3 seconds.
4.3.
Using as a 12V DC power source
4.3.1.
The memory bank may be used to power a 12V DC device via the accessory socket.
4.3.2.
Ensure that the device is switched off before connecting to the memory safe. Switch on when connected.
4.3.3.
If the device draws more than 4A or has a short circuit, the internal circuit breaker in the memory safe will operate. If this happens,
disconnect the 12V device. The circuit breaker will reset automatically once the overload has been removed.
DO NOT use as a power source whilst the unit is connected to a vehicle: this will drain the internal battery, reducing the operating
8
time.
5. MAINTENANCE
5.1.
Battery replacement/removal
5.1.1.
Open the rear compartment and withdraw the battery. Disconnect the spade terminals to release.
5.1.2.
To replace the battery: reconnect the spade terminals, observing the correct polarity and place the battery back into position.
5.1.3.
Close the rear compartment.
5.2.
Cleaning
DO NOT use solvent or abrasive cleaners on this product.
8
Parts support is available for this product. To obtain parts, email sales@sealey.co.uk or telephone 01284 757500
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL For battery removal details, see section 5.1.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
VS2076 Issue:1 - 30/05/18
Advertisement
