Specifying Switch Or Trigger Mode For Buttons (D4S Only) - Peavey D Series Hardware Manual

 To set the end of line (EOL) termination for a panel

Set DIP switch 8 to the on (terminated) position.

Specifying switch or trigger mode for buttons (D4S only)

The buttons on the D4S are always arranged in a set, and can be configured as switches or
triggers.
In switch mode, each button is independent and does not function as part of a mutually
exclusive group. Each button sends alternate on and off commands with each button press. The
LED indicates the on/off status for each button separately. This feature is used primarily to
turn on specific audio functions, such as a mute, or in conjunction with level controls, switches
and simple audio routing.
In trigger mode, each button transmits a momentary signal when pressed. This signal is a
one-shot command that the software recognizes as a trigger. A trigger has no on or off state, it
is simply a momentary logic signal. When a trigger has been activated, the button LED will
illuminate and stay illuminated until another trigger in the same group is activated. The
buttons work in the same way as radio buttons in a software application. They can be used as
preset selectors in all products, and additionally, as a router (source select) control, in some
products. Refer to the product manuals for more information.
Notes:

Before configuring the D4S, make sure that your system is completely wired and
terminated correctly to the NION or Digitool.

The power to the NION or Digitool (and D series network) should be on.
 To specify switch or trigger mode for buttons

Set DIP switch 1 to the on (switch mode) or off (trigger mode) position.
July 7, 2017 Version 2.0.0.0
D Series Hardware Manual
25