Setting The Device Id For A Panel - Peavey D Series Hardware Manual

CAT5 (T568B) plug
1
2
4
5

Setting the device ID for a panel

In a D series control system, each panel must be assigned a device ID. This allows NWare to
identify each physical control on the device when the user interacts with it. For the D4S, the
physical controls are buttons. For the D1V, there is a single rotary control with a push button.
There are 32 device IDs available per NWare project. Device IDs are assigned according to
whether the panels will be working independently, or whether they will work together.
Note: If you change the device ID for a panel, you must power cycle the panel before the
change will take effect.
How panels operate
When panels work independently, pressing a button or turning the knob on one panel changes
a setting in an NWare project that no other panel can access, such as the audio source or gain
for a particular room.
When panels work collectively, it can be in one of two ways:

Several panels set the exact same values in the NWare project. You can interact with the
panel in one of several rooms, for example, and in each case, the exact same settings are
changed.
July 7, 2017
NION RS-485 port
1
2
4
5
Version 2.0.0.0
D Series Hardware Manual
Description
485 +
485 -
Power
Power ground
17