D4S Front And Rear Panel - Peavey D Series Hardware Manual

Chapter 3 - Introduction to the D series
4. Knob Rotary encoder with integral push-switch. Turning the knob adjusts the level of the
wired control. The level is indicated by lit LEDs around the knob. Pushing the knob selects
a device wired to the NWare D series device.
Note: If the LEDs start flashing, this means no NWare D series device in the NWare
project has been assigned the device ID set on the physical device.
5. Mounting Bracket Single-gang (1G) mounting bracket for installation into standard
NEMA 1G switch box.
6. DIP Switch Eight individual switches that assign button mode (switch 1), device ID
(switches 3-7) and EOL termination function (switch 8). Switch 2 is reserved.
7. RJ-45 Connectors Dual RJ-45 connectors for installation into D Series RS-485 network.
These connectors are wired in parallel and include data and power supply connections.
The recommended cable is UTP Category 5 (CAT5) or better.

D4S front and rear panel

1. Label Space Use this area to fix a label identifying the selection that has been made. For
example, the knob could switch between audio sources for background music: CD player
1 and 2.
2. Device selection LED Single-color green LED illuminates to indicate which of the four
devices wired to the NWare D1V device is active.
3. Device selection switch Momentary push button. Pushing the switch selects a device
wired to the NWare D series device. The button operating mode (switch or trigger mode)
is controlled by DIP switches.
Switch mode
10
In switch mode, each button is independent and does not function as
part of a mutually exclusive group. Each button sends alternate on and
off commands with each button press. The LED indicates the on/off
status for each button separately. This feature is used primarily to turn
Version 2.0.0.0 July 7, 2017