mcmurdo Smartfind S20 SRS Installation Instructions

Instructions for Integrating the McMurdo Smartfind S20 SRS to the Mustang Survival EP 38 Inflatable
Ocean Racing Vest
About the S20 SRS:
The S20 is design to be integrated with an inflatable PFD to be activated by the force of inflation. The
S20 can be attached to the right side of the EP 38 Inflatable Vest, clipping onto the safety whistle
attachment strap. The red cap on the S20 will be pulled off during inflation, releasing the antenna and
activating the device. For further information refer to the S20 User Manual.
Integrating the S20 SRS to the EP 38 Inflatable Vest:
•
The S20 comes out of the box ready for manual activation only. This means the orange lanyard will
be tied to the white section of the S20 (Fig. 1). To allow for the S20 to be activated by inflation,
undo this knot so the long lanyard hangs lose from the red cap
•
Pull out the orange arming tab by slightly lifting up the end of the tab (the side with the engraved
arrows) and sliding it in the direction of the arrows. The white section of the S20 should now read
"ARMED" (Fig. 1)
•
Ensure that the webbing clip is attached to the back of the S20.
•
On the PFD, undo the Velcro™ tab on the wearer's right side at the bottom, to expose the zipper.
Undo the zipper by placing a finger underneath the zipper end and running it up, toward wearer's
face. Unfold the material to expose the whistle and light attachment tabs.
•
Clip the S20 onto the tab that the whistle is attached to (Fig. 2).
NOTE: The whistle is removed for clarity