Sharp PN-85TH1 Operation Manual page 34

Menu Items
nSETUP
DATE/TIME SETTING
Display the date and time.
When select SET, input mode change to APPLICATION, and you can set the date and time.
When APPLICATION is set to DISABLE, SET does not appear. Set in the displayed screen.
TIME FORMAT (when APPLICATION is ENABLE)
Set the time display format.
Select the display format, and select SET.
DATE/TIME FORMAT (when APPLICATION is DISABLE)
Set the date/time display format.
SCHEDULE (See page 40.)
You can turn the power on/off and change the screen brightness at a specified time.
LANGUAGE
Set the display language for the menu screen.
INPUT SELECT
DisplayPort STREAM
Set how DisplayPort is used.
If a device that do not support DisplayPort1.2 is connected, set to SST1.
SST1 ....Use as single stream (DisplayPort1.1).
SST2 ....Use as single stream (DisplayPort1.2).
HDMI MODES
HDMI MODES settings change how the content displayed is processed and decoded using the HDMI input terminal or
expansion slot (when you have used the expansion slot to expand the function).
MODE1 ..... Normally used.
This will support most common color spaces and other encoding signals.
MODE2 ..... This should be used for YCbCr 4:2:0 at 4K Vsync 50/60 Hz signals.
Also use this when a non 4K input signal does not display correctly in MODE1.
CEC SETTING
HDMI CEC LINK
AUTO ........ HDMI CEC function is used.
If the device connected to the HDMI input terminal supports CEC, the input mode of the monitor changes to
HDMI when playback starts on the device.
OFF ........... HDMI CEC function is not used.
AUTO POWER ON
This can be set when HDMI CEC LINK is set to AUTO.
If the device connected to the HDMI input terminal supports CEC, you can specify whether or not the monitor power turns on
when the device power is turned on.
INPUT MODE NAME
For each terminal, you can change the input mode name that is displayed during input mode selection or display.
The names of INPUT1 to INPUT6* can be changed. (*Factory default.)
(1) Select the input mode name (INPUT1 to INPUT6) that you want to change, and press the ENTER button.
If the input mode name can be changed, "EDIT:[ENTER]" will appear.
(2) Move the cursor to the character that you want to change with the
button.
Change the character type with the MODE button (upper case alphabet, lower case alphabet, numbers, symbols).
(3) When you have finished the change, press the ENTER button.
Up to 18 characters can be used.
34
E
or button, and change the character with the or