Table of Contents
Advertisement
4.
Verify that the machine is operating correctly
by pushing the START button.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5.
Press the STOP button to stop the machine.
6.
WITHOUT resetting the switch, press the
START button. The machine should not start.
—If the machine does not start, the STOP
button safety feature is working correctly.
The test run is complete.
—If the machine does start (with the STOP
button pushed in), immediately disconnect
power to the machine. The STOP button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.
-20-
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1.
Table Parallelism (Page 36).
2.
Infeed Table Calibration (Page 40).
3.
Fence Stop Settings (Page 42).
4.
Verify V-Belt Tension Adjustment (Page 44).
Model G0495X (Mfd. Since 07/19)
Advertisement
Table of Contents
