Troubleshooting - Nakanishi E4000 - SRB Operation Manual

6 . TROUBLESHOOTING

If a problem or concern occurs, please check the following prior to consulting your dealer.
Trouble
Emergency Stop function is
not function properly.
External Input / Output
Signal is not output correctly.
7 . DISPOSAL OF THIS PRODUCTS
When disposal of a E4000 SAFETY RELAY BOX is necessary, follow the instructions from your local government
agency for proper disposal of electrical components .
Cause
Relay Cord Plug is not connected
to the MOTOR-A Connector of the
CONTROLLER and MOTOR-IN
Connector of the SAFETY RELAY BOX.
Emergency Stop Cord Plug is not
connected to the EMG Connector of
the CONTROLLER and the SAFETY
RELAY BOX.
Motor Cord plug is not connected to
the MOTOR-OUT Connector of the
SAFETY RELAY BOX.
Emergency Stop Cord is disconnected.
Inspection / Corrective Action
Connect to the Relay Cord Plug
correctly to the MOTOR-A Connector
of the CONTROLLER and MOTOR-IN
Connector of the SAFETY RELAY BOX.
Connect to the Emergency Stop Cord
Plug correctly to the EMG Connector
of the CONTROLLER and the SAFETY
RELAY BOX.
Connect to the Motor Cord Plug correctly
to the MOTOR-OUT Connector of the
SAFETY RELAY BOX.
Replace the Emergency Stop Cord.
(Return to NAKANISHI dealer service.)
15