Electrolux EWW8025DGWA User Manual page 14

Table of Contents

Advertisement

Available languages

Available languages

14
www.electrolux.com
Duration of the drying cycle
The drying time can vary according to :
-
the final spin speed;
-
dryness level (Extra Dry or Cupboard
Dry or Iron Dry);
-
the type of laundry;
-
the size of load.
Fibre residue
After drying fluffy fabrics, such as new
towels, it is advisable to perform a
"Maintenance Wash" (see page 27) to
ensure that any residue that may remain in
the tub is completely removed and does not
stick to garments dried afterwards. After
each drying cycle, clean the drain pump
filter. Please refer to care and cleaning in
section 10 "CARE AND CLEANING".
Additional drying
Should the laundry still be too wet at the
end of the program, set another short
drying cycle.
The final part of a washer- dryer cycle
occurs without heat (cool down cycle).
This ensures the laundry will be left at a
low temperature.
WARNING!
To prevent the formation of creases or
shrinking of fabrics, avoid excessive
drying.
Delay Start (
This option makes it possible to delay the
start of the program by 30 min, 60 min or
90 min and then by every hour from 2 to
19 hours.
The delay you have selected is indicated
on the display. The end time will increase
in order to show you the selected delay.
You must select this option after you have
set the program and before you press the
"Start/Pause
If you wish to add laundry in the machine
during the delay time, press "Start/Pause
" touchpad to put the machine in pause
mode. Add laundry, close the door and
press "Start/Pause
) Touchpad
" button.
" touchpad again.
You can cancel the delay time at any
moment, by pressing "Delay Start"
touchpad repeatedly till the display shows
delay time "
", then press the
"Start/Pause
" touchpad.
Soak (
) Touchpad
This option allows you to soak heavily
soiled clothes and stained items at
the beginning of the wash before main
washing phase.
This option will increase the duration
of the program selected for about 60
minutes. And uses more water from
normal wash. The process is as follows.
When you use
the "Soak"
option, pour
detergent
into the
compartment
marked
.
1.
After press Start/Pause touchpad,
the machine will start add water to
the washing drum, which will start to
rotate slowly to dissolve detergent
and evenly distribute cloths. (this
takes about 30 minutes)
2.
The machine will enter the process
3.
Once the soaking process is
complete, the machine will drain
the water in the washing drum out
automatically and fill in water once
again to be used for main washing
phase.
of soaking, The
washing drum will
stop and rotate once
in a while in order to
redistribute cloths.
(this takes about 30
minutes.)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents