Triumph IP12 User Manual page 13

Installing the Infusion Pump and Pole Clamp
(1) Install the pole clamp/cage mount using
provided hex wrench and screw.
(2) If using as a cage mount then leave rotary
knob off of pole clamp and install the mount
vertically as shown below leaving the "split" side
of pole clamp at the top. Ready to mount to cage.
If using a pole please proceed to step 3.
(3) If mounting on pole, rotate the pole clamp
screw(knob) and unscrew to leave space. Lock
the Pole Clamp on the infusion stand, adjust the
position of the infusion pump, tighten the pole
clamp to fix the infusion pump on the infusion
stand (shown in drawing to the right). Hold the
infusion pump when tightening the fixing clamp;
loose it after tightening to avoid falling.
(4) The pole clamp supports the vertical pole at
default state. To adjust the pole clamp direction,
please remove the bolt from the pole clamp
screwdriver, take out the pole clamp and adjust the
direction, then tighten the bolt.
13