Layout; Key Fob Mounting Kit; Key Fob Pairing Procedure - Dometic Seastar DCM User's Manual And Troubleshooting Manual

How The System Works

3 .3 Layout

1
5
11
3
10
Item Name Description
1 Positive Terminal Connection to the house battery power.
2 Negative Terminal Connection to the house battery ground.
3 NMEA 2000 Connector Connection to NMEA 2000 network.
4 Ethernet Connector Optional.
5 Channel Activity LED LED ON shows when load is active.
6 Power LED LED ON shows when DCM is powered.
7 Error Code LED Error code list can be found in Section 3.1.
8 Always ON Channel Fuses Fused output channels powered when DCM is powered.
9 Fuse Bypass Use fuse bypass to turn the channel on in case of failure.
10 Input Channel Label Channel inputs going to the DCM. This could be physical switches
or analog sensor feedback.
11 Output Channel Label Channel outputs and fuse values to loads controlled by DCM.
12 Serial Number Label DCM serial number.
13 DCM Label DCM info on: Boat model and model year / DCM part number and
revision / Config part number and revision.

3 .4 Key Fob Mounting Kit

INSERT INTO
HOLDER
Figure 2-4. Key Fob Dash Mounting kit. NOTE: May already be
installed on your boat.
4
6
7
8
9
12 13
First Fish Port
Port Fill
Pump
O L M H
Nav/Anchor
Lights
SCREW INTO
DECK
O N A
Powerpoles
Down
03:05

3 .5 Key Fob Pairing Procedure

In case your key fob lost pairing or you received a new key fob
2
follow this procedure to pair the key fob to the DCM:
1. On the MFD Switching page find Remote Learn button.
2. Press and release the Remote Learn button on the MFD (the
button is located on the MFD Switching page).
4
3. Press and release any button on the Key fob.
4. Wait 20 seconds for the DCM to exit programming mode.
5. The transmitter and DCM are now paired.
6. Repeat the pairing process for additional transmitters.
7. Up to 40 transmitter addresses can be stored in the DCM.
If a transmitter is lost or stolen, the user may want to clear it
from the DCM's memory so that it can no longer control the
DCM.
To erase all transmitter addresses, press and hold the Remote
Learn button on the MFD for 15 seconds.
Note that all transmitters must then be re-paired with the
DCM.
First Fish Stbd
SWITCHING
Port Recirc Port Pump Stbd Pump
Pump Out Out
O L M H
Courtesy
Bilge Vent
Light
ProTap Set Sweet
Shutdown
Mode Spot
P
Waypoints Info
M
Figure 2-5.
Hole Shot Sweet Spot
Stbd Recirc Stbd Fill
Trim
Pump Pump
O L M H O L M H Up
Shallow
Jackplate Powerpoles
Water
Up Down
Set Shallow Set Hole Remote First Fish
Water Shot Learn
Home
Menu
How The System Works
Night Running
GPS Speed
0.00
m
h
RPM (1)
0
R
P
M
Down
Eng. Voltage (1)
12.1
V
Depth
f
– – – –
t
Up
Trim
0%
Port
1
Jackplate
46%
1
Mark SOS
EN