Jeld-Wen Siteline Glider Brio Installation Instructions Manual page 6

1
INSTALLING SCREEN (CONTINUED)
f. Fitting Top Track Cassette
The top track cassette installation is the same as the sill, with the
exception of using the WS-CEIN parts to hold the cassette in the track
before installing the screen .
<144 (3657) x1 per cassette assembly
>144 (3657) x2 per cassette assembly
NOTE: Fit WS-CEIN before fitting cassette into the top track .
CASSET TE
ASSEMBLY
B WS-CEIN
WS-CEIN
g. Cord Tensioning
Using an Allen wrench, loosen set screw in anchor and tension each cable
starting with the anchor closest to the center of the door .
Note: Ensure that the screen assembly is tightly compressed . Slide cord
anchors to take up the slack and stretch a further 9/16" .
TIGHTEN
ADJUSTABLE
ANCHORS
h. Cut Tape and Check Tension
Cut tape at the jambs and test
operation of screen .
Note: If adjustments are
needed, go to Step 2- Handle
Bar Adjustment .
6
Installation Instructions
for Siteline
®
Distributed by JELD-WEN
WS-CEIN
B A
CASSET TE
ASSEMBLY
A
B
KEEP COMPRESSED
ADJUSTABLE
CASSET TE
ANCHORS
ASSEMBLY
TIGHTEN
B
Low-Friction Glider Wall System Brio
™
(JII-90048)
®
i. Preparing Handlebar
See page 9 for Double Screens . Ensure the cords are aligned around each
roller and all cords are aligned around end rollers . Insert weatherseal into
end of handlebar and cut to length . Insert plastic inserts into ends of
handlebar to contain weatherseal .
Align all cords on
end rollers
Align cords on
individual rollers
Align all cords on
end rollers
A A
j. Fitting the Handlebar Cover
A A
Center the handlebar vertically
on the screen .
NOTE: The handlebar is 11/16"
shorter than the screen .
NOTE: Before fitting handlebar
cover, ensure the cords are not
twisted or tangled .
Align all
Cords on
end rollers
Align Cords
on individual
rollers
Align all
Cords on
end rollers
Pleated Screens
®
iii. SNAP
HANDLEBAR WS-HDCEXP
iii. SNAP
SCREEN
ASSEMBLY
NOTE: Ensure sticker is completely
removed after checking .