Siteline Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® INSTALLING SCREEN Note: Carefully remove wrapping . Ensure that the screen assembly is c. Align Cords tightly compressed . Stretch out cassette assemblies and cords, ensuring cords are tracking on a.
Page 5
Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® INSTALLING SCREEN (CONTINUED) e. Fitting Bottom Channel Cassette - Low Friction Glider iii . Slide cassette assembly towards jamb until plastic part “A” lines up with the end of the sill frame extrusion . Make sure this part “A” is NOTE: Ensure the cords are on top of the cassette .
Page 6
Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® INSTALLING SCREEN (CONTINUED) i. Preparing Handlebar f. Fitting Top Track Cassette See page 9 for Double Screens . Ensure the cords are aligned around each The top track cassette installation is the same as the sill, with the roller and all cords are aligned around end rollers .
Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® HANDLE BAR ADJUSTMENT Sightlines can be adjusted by loosening the screw and tightening the cords . Cords in sill track adjust upper cords and cords in the head track adjust lower cords .
Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® SCREEN ADJUSTMENT The vertical slop in the screen should be between 1/4" (max) at any point NOTE: Adjustments need to be made on both interior and exterior sides in its travel .
Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® COMMISSIONING & FINAL FITTINGS Commissioning 1 . Ensure sill is free from dirt and debris . 2 . Ensure screen slides freely from side to side .
Page 10
Installation Instructions for Siteline Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® SCREEN REPLACEMENT a. Remove Channel Covers HEAD PIVOT WS-COVEXP SILL b. Remove Cassettes iii. CASSET TE ASSEMBLY ROTATE PIVOT c. Remove Screen Assembly Tightly wrap assembly with masking tape i.
Low-Friction Glider Wall System Brio Pleated Screens ® ™ ® Distributed by JELD-WEN (JII-90048) ® LIMITED WARRANTY Care & Maintenance Brio USA (the supplier) warrants that the Brio 612 Retractable Pleated Insect Screen is supplied free of manufacturing defects and material flaws .