Jeld-Wen Siteline Glider Brio Installation Instructions Manual page 5

for Siteline
1
INSTALLING SCREEN (CONTINUED)
e. Fitting Bottom Channel Cassette - Low Friction Glider
NOTE: Ensure the cords are on top of the cassette .
i . Insert cassette assembly (plastic part "A") into sill channel .
ii . Rotate 90° to snap in place . Tabs on "A" will hold the end of the
cassette assembly in place . Lower cassette assembly into sill .
B
i.
CASSET TE
ASSEMBLY
A
iii.
A
B
Installation Instructions
Low-Friction Glider Wall System Brio
® ™
Distributed by JELD-WEN
ii. B
ROTATE
PIVOT
A
iv.
Pleated Screens
®
(JII-90048)
®
iii . Slide cassette assembly towards jamb until plastic part "A" lines
up with the end of the sill frame extrusion . Make sure this part "A" is
contained in the sill and is not pushed past end of the screen frame .
iv . Screw cassette into place .
5