Installing Screen - Jeld-Wen Siteline Glider Brio Installation Instructions Manual

1

INSTALLING SCREEN

Note: Carefully remove wrapping . Ensure that the screen assembly is
tightly compressed .
a. Wrap Screen
Using low adhesive tape, wrap the screen tightly against the jamb . Tape
may be factory applied . Do NOT remove until after screen has been
installed in step "B" .
Apply
Note: Unwrap cables and stretch out cassette assemblies and cables
being careful to avoid tangling of cords .
b. Insert and Snap
Insert screen assembly into screen sill and snap into place in the jamb
mount . Assembly is non-handed .
ii. SNAP
4
Installation Instructions
for Siteline Low-Friction Glider
®
Distributed by JELD-WEN
MASKING
TAPE
SCREEN
ASSEMBLY
CASSETTE
ASSEMBLIES
Wall System Brio
™ ®
(JII-90048)
®
c. Align Cords
Stretch out cassette assemblies and cords, ensuring cords are tracking on
end rollers .
NOTE: Ensure the cords are not twisted or tangled .
Ensure cords
are aligned
on individual
rollers .
d. Cassette Assembly
B
B
CORDS
Pleated Screens
Align cords
on rollers .
B A
CASSETTE
ASSEMBLY
B A
A
A