Safety; Intended Use; Important Safety Instructions - SMA DATA MANAGER L Operating Manual

Hide thumbs Also See for DATA MANAGER L:
Table of Contents

Advertisement

SMA Solar Technology AG
2

Safety

2.1

Intended Use

The SMA Data Manager L is the central communication unit for monitoring, control and grid-
compliant output regulation of large-scale PV power plants with central or string inverters. The
following is included into the SMA infrastructure via the Ethernet interface of the
SMA Data Manager L: system components and systems including energy generators and loads, I/
O systems and meters. At the same time, the SMA Data Manager L supports communication with
up to 200 devices.
The product is designed for indoor use only.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the
intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal
or national laws, regulations or codes applicable to the installation, electrical safety and use of the
product. SMA Solar Technology AG assumes no responsibility for the compliance or non-
compliance with such laws or codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As
with all electrical or electronical devices, there are residual risks despite careful construction. To
prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and observe all safety information at all times.
Operating manual
EDML-10-BE-en-10
2 Safety
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edml-10

Table of Contents