Advertisement
PIN KEY
The Key option requires a 4-digit PIN key to be loaded at the Site Controller. Use the command
LOad KEY to enter this PIN. The LOad KEY command requires 18 digits to be entered at the
prompt. Key systems will use only the last 4 digits. Place 0's (zeros) in the first 14 digits with the
final 4 digits the required PIN key. Use the example as a guide.
If PINs are being calculated from a mag card in a card/key combination, the PIN key is still loaded
in SYS_PAR.
Example:
PIN is 1234. (In actual use, data is masked; it is shown here for example only.)
HQÂGA
Â
↵
Gs“5Â
Â
Upon completion of this Configuration section, your converted Islander with Key option system
should be working and fully operational. If you have any questions, please call Gasboy Technical
Services at 1-800-444-5529.
04/15/03
!"#$
Â
↵
Islander to FleetKey Conversion
11
Advertisement
