Table of Contents
Advertisement
6 Connect the Alarm to your APP
6.1 Reset the WiFi: Disarm the system→Type Admin Code:123456 & select
"Enter". Go to the settings menu→choose "WIFI Config"→choose
"Connecting", then press "Enter" button to start the network setting.
The following steps are to be carried out on the app
6.2 Add Device: choose "Add Device"→" Others"→" Wi-Fi Connector".
6.3 Enter the password of the Wi-Fi network (Your router's password that
the APP was connected with), wait for about 20 seconds for a response.
6.4 Now you can set the alarm name to complete the connection.
Device List Interface
Connect the Alarm to Servers
Enter Wi-Fi Password
Set Alarm's Name
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Smart Alarm System and is the answer not in the manual?
Questions and answers
Cannot connect system to WiFi
To connect the Curv Smart Alarm System to WiFi:
1. Disarm the System: Start by disarming the alarm system.
2. Enter Admin Code: Type the admin code `123456` and select "Enter".
3. Access WiFi Settings: Go to the settings menu and choose "WIFI Config".
4. Start Network Setting: Select "Connecting" and press "Enter" to begin the network setup.
5. Use the App:
- Open the app and choose “Add Device” → “Others” → “Wi-Fi Connector”.
- Enter the password for your WiFi network (the same network the app is connected to).
- Wait approximately 20 seconds for a response.
6. Set Alarm Name: Once connected, set the alarm name to complete the WiFi connection.
This answer is automatically generated
How to change battery in remote control