Table of Contents
Advertisement
By remote control
Press on the "Home" button of the remote control .
On the control panel
Click Home mode button.
By SMS
Send 2 to the phone number of the SIM card in the control panel.
(Only saved SMS numbers can disarm the system by SMS.)
Disarm the system
When your system is disarmed, all detectors are inactive except
those assigned to the 24H zone.
By app
Connect to your alarm and click on "Disarm".
By remote control
Press on the "Disarm" button of the remote control .
On the control panel
User code1234+ Disarm button.
By SMS
Send 0 to the phone number of the SIM card in the control panel.
(Only saved SMS numbers can disarm the system by SMS.)
SOS function
The SOS function enables you to trigger your alarm immediately.
By remote control
Press on the "SOS" button of the remote control.
On the control panel
Press and hold the SOS(#) button on the control panel.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Smart Alarm System and is the answer not in the manual?
Questions and answers
Cannot connect system to WiFi
To connect the Curv Smart Alarm System to WiFi:
1. Disarm the System: Start by disarming the alarm system.
2. Enter Admin Code: Type the admin code `123456` and select "Enter".
3. Access WiFi Settings: Go to the settings menu and choose "WIFI Config".
4. Start Network Setting: Select "Connecting" and press "Enter" to begin the network setup.
5. Use the App:
- Open the app and choose “Add Device” → “Others” → “Wi-Fi Connector”.
- Enter the password for your WiFi network (the same network the app is connected to).
- Wait approximately 20 seconds for a response.
6. Set Alarm Name: Once connected, set the alarm name to complete the WiFi connection.
This answer is automatically generated
How to change battery in remote control