Page 2
(x8) #8 X 1” (x4) AWLA Counter & Bar Height Powered Assembly Instructions DO NOT COMPLETELY UNWRAP TABLE TOP UNTIL STEP 6. Place table top upside down on a Feed the power cable up and into the channel leg, then install plate to secure (illustrated clean surface.
Page 3
AWLA Counter & Bar Height Non- Powered Assembly Instructions DO NOT COMPLETELY UNWRAP TABLE TOP UNTIL STEP 6. Place table top upside down on a With two assemblers holding up the foot rail so it lines up horizontally to the pilot holes located clean surface.
Page 4
With a minimum of two assemblers, proceed to flip the table and place in its final position. The table top can now be completely unwrapped. AWLA Conference Height Non- Powered Assembly Instructions With a minimum of two assemblers, proceed to flip the table and place in its final position. The Place table top upside down on a clean surface.