Lighting; Programming Recirculation (Optional); Intouch - Novy Flat'line 7640 User Manual

To decrease the power level press key
− Three green LEDs 5 show positions one to three.
6
− The red LED shows the Power position. The Power
position is only used if there are strong odours, or a lot
of smoke or vapour. Its use must be kept to a minimum
because of the large extraction of air in this position.
− The Power position automatically goes back to speed
three after 6 minutes.
− The motor has a thermal switch that switches the motor
off with overheating. After cooling the motor will switch
on again.


Determining the cause of overheating is re-
quired. This can be caused for example by a
pan fire, the impeller motor being blocked or
an object getting in the exhaust opening and
causing it to be partly or fully blocked.
Auto-Stop
To avoid the extractor hood from staying on, the motor is
automatically switched off after 3 hours (only if in 3 hours
operation has not been changed). The extractor hood
lighting stays on.

2.3 Lighting

Turning the lighting on and off
To turn the lighting on or off press
The light works independent of the motor.
The LED lighting has a soft-on/soft-off function, meaning the
lighting will go gently on and off.
When switching the lighting on it will always go to full
power and can also be used when the fan is switched off.
Dimming the LED lighting
When the LED lighting is switched on you can dim it by
keeping key pressed.
4

2.4 Programming recirculation (optional)


If recirculation is selected programming must
take place once.
This programming function activates the replacement
indicator of the monobloc recirculation filter and the delay
time is changed.
.
2
.
4
– 30 –
Activating programming
− The motor must be switched off
− Press the and the
2
seconds until the red LED flashes 5 times.
The following functions then operate:
− Replacement indicator of the monobloc filter is activated.
After a set time a red indicator light on the appliance
shows that the monobloc filter must be replaced.
− The delay time is set to 30 minutes (instead of the default
10 minutes).

Use the delay time of 30 minutes so the
cooking odours can be properly removed in
the monobloc filter.
Read paragraph 3.4 for more information about replacement
of the monobloc recirculation filter.
Deactivating programming
− The motor must be switched off
− Press and 3 at the same time for 3 seconds until
2
the 3rd green LED flashes 3 times.
The delay time is again set to 10 minutes (instead of 30 min-
utes) and cleaning indicator for recirculation is switched off.
2.5 InTouch and remote control (accessory)
The extraction hood has the InTouch function. If you have
an induction hob from Novy with InTouch, you can operate
the extraction hood from the hob. There is also the option
that the extraction hood can be operated with a remote
control (accessory).
The InTouch function is off by default. The function can be
switched on by pressing the
time for 3 seconds.
The 2nd and 3rd LEDs flash 3 times to confirm (the appli-
ance must be switched off).
To switch the InTouch function off press the
keys at the same time for 3 seconds and the 2nd and 4th
LEDs flash 3 times to confirm. (The appliance must be
switched off).
keys at the same time for 3
3
and keys at the same
1 3
1
and
2