6. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
E-lock
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Note: To remove the screws, you need a special tool (T15 star wrench).
1. Remove the computer cover. See "Computer cover" on page 61.
2. Disconnect the E-lock cable from the system board.
3. Remove the E-lock.
4. Install the E-lock.
5. Connect the E-lock cable to the system board.
6. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
88
M70s and M80s Hardware Maintenance Manual