All Lights Flashing? - Russell Hobbs SmartGlide PRo Instructions Manual

69 It's best to do this on top of a towel on the work surface in the kitchen, as you're
likely to spill a bit, and you'll need access to water and a sink (or a basin).
70 Remove the reservoir (you're going to turn the base unit upside down).
71 Set the iron down on the work surface – take care not to scratch the soleplate.
72 Turn the base unit upside down.
73 Use a coin or screwdriver to turn the cover 90°
anti-clockwise to unlock it.
74 Move the cover sideways to expose the drain.
75 Use the hexagonal wrench to unscrew the drain cap.
76 Turn the base unit over, and empty the boiler into
the sink.
77 Turn the base upside down again, and pour the
vinegar/water mix into the hole.
78 Replace the drain cap and shake the base unit from
side to side.
79 Leave it for half an hour, then unscrew the cap again.
80 Turn the base unit over, and empty the boiler into
the sink.
81 Now rinse, to remove scale and vinegar:
a) turn it upside down, fill with water
b) turn it back, and empty it into the sink
82 Repeat point 80 till the water that comes out is clear, free of scale particles, and
doesn't smell of vinegar.
83 Finally, replace the cap, replace the cover, turn the cover 90° clockwise to lock it
closed, turn the base unit upright, and store it away.
, Products returned under guarantee with faults due to scale will be subject to a
repair charge.
C ALL LIGHTS FLASHING?
84 To ensure that it gets descaled at least once a year, even in soft water areas, the iron
has an internal counter.
85 When the counter reaches 1000 minutes of use, it stops the boiler, and makes all the
lights flash.
86 To return it to working condition, press the 2 button and hold it in for 5 seconds.
87 If you have recently descaled the boiler, carry on ironing.
88 If you haven't recently descaled the boiler, descale it now.
position
drain cap
7
closed
cover
hexagonal wrench
cover
open
position
loosen
tighten