Adjusting The Blade Height; Changing The Bevel - Delta 36-6023 Manual

ADJUSTMENT
WHEEL

ADJUSTING THE BLADE HEIGHT

For all through cuts, the top of the blade points should be above the workpiece and the bottom of the blade gullets are below the
top surface of workpiece.
For non-through cuts, the top of the blade points should be set to the depth of the cut.
To adjust the height of the blade, refer to Figure 42 and do the following:
Make sure the bevel/height adjustment locking lever is in the locked position.
Adjust the blade height by turning the bevel/height adjustment wheel. Clockwise will raise the blade and counterclockwise lowers it.

CHANGING THE BEVEL

Unlock the bevel/height adjustment locking lever by pulling it into the unlock position.
Holding knob/wheel, slide the bevel indicator to the desired angle.
When the blade is at desired angle, lock the bevel/height adjustment locking lever by pushing it down to the lock position.
See Figure 42.
MAKING ADJUSTMENTS
LOCKING
LEVER
UNLOCK
LOCK
FIGURE 42
34