Table of Contents
Advertisement
CHECKING RIVING KNIFE
ALIGNMENT
Before connecting the table saw to the
power source and operating the saw, ALWAYS inspect
the blade guard assembly and riving knife for proper
alignment and clearance with saw blade. Check the riving
knife alignment after each blade change.
TO CHECK ALIGNMENT:
1.
Horizontal Alignment: Lay a straight edge on the table
against blade face
the riving knife
, see Figure 39. The riving knife should
B
just touch the straight edge. Be sure the straight edge
goes between the teeth and rests on the blade face and
the riving knife for proper alignment.
2.
Vertical Alignment: Place a combination square on the
table and against the blade face and make sure it extends
up along the riving knife
knife and blade should touch the carpenter's square with
no gaps. Be sure the straight edge goes between the teeth
and rests on the blade face and the riving knife for proper
alignment.
NOTE: If the riving knife and blade are out of horizontal or vertical
alignment, refer to riving knife alignment instructions on page 27
of this manual.
CHECKING BLADE PARALLELISM
TO MITER GAUGE GROOVE (HEEL)
See Figures 41 & 42.
MUST be parallel to miter gauge groove so that
•
Blade
A
wood does not bind, resulting in kickback.
Failure to do so could result in serious personal
injury.
•
To reduce risk of injury from kickback, align miter gauge
groove to blade
following any blade adjustments.
A
DO NOT loosen any screws for this adjustment until alignment has
been checked with a square to be sure adjustments are necessary.
Once screws are loosened, items MUST be reset.
NOTE: Unplug saw. Remove blade guard and anti-kickback pawls.
Raise the blade
by turning height adjusting wheel.
A
1.
Mark beside one of blade teeth at front of blade
(Figure 41-1). Place the combination square against the
marked tooth at the front of the blade
of the square against the miter gauge groove as shown.
2.
Turn blade
so that marked tooth is at back. Move
A
combination square to the rear and again measure the
distance (2). If the distances are the same, blade
parallel.
ADJUSTING BLADE PARALLELISM
TO MITER GAUGE GROOVE (HEEL)
The #36-5000 T2 Series Table Saw blade alignment has been set
at factory to ensure full accuracy when assembled. If you have
already checked the blade parallelism and your blade is not parallel
to the miter slot, please contact DELTA
1-800-223-7278.
PREPARING TO CUT
and make sure it extends out along
A
see Figure 40. The riving
B
with the head
A
Customer Support at
®
1
A
is
A
1
33
B
A
Figure 39
Figure 40
A
2
Figure 41
A
2
Figure 42
B
Advertisement
Table of Contents
