Oras 182 Installation And Maintenance Manual page 3

Dishwasher valve 182
The dishwasher connected to this valve must
be equipped with a siphonage guard.
Installation:
– The dishwasher valve can be installed in a
ø 33 – 35 mm aperture.
– The maximum surface installation thickness for
the dishwasher valve is 50 mm. If installed on a
thicker table-top, use extension screws for a
maximum installation thickness of up to 80 mm
– Push the dishwasher valve body (1) in place.
Make sure that the O-ring (2) is in place.
– Position the adapter sleeve (3), tightening plate
(4) and locking nut (5) in place. Tighten the
locking nut.
– Connect the inlet water to the ø 10 mm Cu pipe.
– Attach the dishwasher's inlet hose to the G ½
coupling.
Note!
– If the dishwasher is not connected to the valve,
the coupling (G ½) for the dishwasher must be
plugged with the enclosed G ½ capnut.
3
GB