Advertisement
Manipulator Arm Setup Instructions
1)
Make sure the robot is powered OFF (i.e., make sure there is no battery in the robot
and/or that the battery is pulled out like in the picture above) before attempting to install
arm. The robot MUST be powered off when installing any accessories onto the robot.
2)
Remove the payload bay covers from Bay #1 (closest to the front of the robot) and Bay
#3 (the smaller bay back by antenna) using a coin or flathead screwdriver to release each
screw.
The arm will only fit in payload Bay #1 – do NOT remove the cover from Bay #2, as
the arm will not fit there. The rear weight goes in payload Bay #3.
4
Avatar® Manipulator Arm User Manual
12/2012
Advertisement
Need help?
Do you have a question about the Avatar II and is the answer not in the manual?
Questions and answers