Summary of Contents for Delta High Bay Luminaire Series
Page 1
High Bay Luminaire Series INSTALLATION INSTRUCTIONS The High Bay Luminaire is ideal for installations with mounting heights over 25 feet. The fixture can be mounted with a hook or pendant with flexible adjustments to create uniform light from fixture to fixture.
Page 2
2. The Weight of High Bay fixture is approximately 19.8 lb. Please ensure the structure and the suspending cable/chain are suitable for the weight of the fixture. 3. To make electrical connections, attach the lead wires according to the colors below. ...
PENDANT MOUNT INSTALLATION: The fixture mounting receiver is threaded for 3/4” NPT pipe. 1. Feed the power cable through the conduit, and into the junction box. Attach the fixture to the conduit. 2. Insert set screw in order to secure the fixture to the Pipe.
Page 4
3. The fixture should already be factory set for correct balance and orientation. If adjusting balance or orientation is necessary, make corrections using the adjustment screws in the locations shown Adjustment screws 4. Make wire connections inside the junction box according to the following color wires : ...
WALL MOUNT INSTALLATION 1. To pre-assembled bracket and luminarie .Use screw and washer to fix the luminaire on the structure. Suggest to use 3/8” (M10) Screw and T 2.0 min washer. bracket 2. Loosen the M10 and M4 screw, and tilt the luminaire to the determinded direction. If determinded, fixed the Screw Torque Suggestion: M10: 18 ft-lbs (245 Kgf.cm)
Page 6
AIRCRAFT CABLE INSTALLATION: 1. Aircraft cable assemblies to the luminaire with two aircraft cable assembly as shown below Notes: a. The assembly location must be shown below b. Do not exceeded angle greater than a 30° between the cables and the gravity line 30 deg Max...
2. Connect power cable conductors as follows: Green wire connects to Safety Ground. White wire connects to Neutral Black wire connects to Live SAFETY CABLE INSTALLATION: 1.Attach one end of the safety cable through the hole between the fin on the luminarie 3.
Page 8
1~10V DIMMING WIRING INSTRUCTION DB series of high bay fixtures come standard with 1-10V dimming interface. The dimming is controlled by 1~10VDC dimming signal (to be provided by other devices). An 8 to 10V DC signal will have about 100% lumen output. A 0 to 1V DC signal will have about 10% lumen output.