Idex Liquid Controls A8180 Series Installation-Parts page 34

5. Pull the float, along with the attached reed strips, out from the
bottom of the air eliminator (shown on the right). If the float is
heavy and full of product, replace it with a new float
assembly.
6. If one of the reed strips is broken, remove it and replace with
a new reed strip.
7. Begin reassembly. Push the float, along with the attached
reed strips, up into the air eliminator cavity. Pull the reed
strips out of the side slots (shown on the right). Hold the reed
strips down and screw them down with the reed screws. If
the air eliminator had a lock nut and a bushing on the bottom
of the guide post, replace them.
8. Replace the valve plate, cover gasket, and cover. Tighten the
cover screws to a torque of 17.5 - 20.5 ft-lbs.
Get the latest PDF manual:
Mobile/online version of this manual:
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
Mechanical Air & Vapor Eliminators
34