Assembly - MAKO TOOLS SROM 1197 Instruction Manual

•
Observe the maximum speed. The maximum speed specified on the multi-piece blade or cutter
head may not be exceeded. If specified, observe the speed range.
•
Confirm the motor/saw blade direction of rotation.
•
Do not use any multi-piece blades or cutter heads with cracks. Discard them. Repairs are not
permitted.
•
Clean grease, oil and water off the clamping surfaces.
•
Do not use any loose reducing rings or bushes for the reducing of holes on saw blades.
•
Make sure that fixed reducer rings for securing multi-piece blades or cutter heads have the same
diameter and have at least 1/3 of the cutting diameter.
•
Make sure that fixed reducer rings are parallel to each other.
•
Handle multi-piece blades or cutter heads with caution. They are ideally stored in the original
package or special containers. Wear protective gloves in order to improve grip and to further
reduce the risk of injury.
•
Prior to the use of multi-piece blades or cutter heads, make sure that all protective devices are
properly fastened.
•
Prior to use, make sure that the multi-piece blade or cutter head meets the technical requirements
of this electric tool and is properly fastened.
•
Only use the supplied saw blade for sawing operations in wood, materials similar to wood, plastics
and non-ferrous metals (This tool is NOT suitable for magnesium and alloys containing
magnesium).
6. BEFORE STARTING:
•
Assemble the machine in a stable position, in other words on a workbench, a sub-frame or the like.
Secure it if you wish to use the machine on a stationary basis.
•
Before starting the machine, check that all covers and safety equipment are correctly fitted.
•
The saw blade must be able to run freely.
•
Check all the moving parts to ensure that they move easily.
•
Before you connect the machine, check the information on the rating plate against the mains data.
Warning! Always pull the power plug before making adjustments to the equipment.
7.

ASSEMBLY:

Warning! Always pull the power plug before making adjustments to the equipment.
7.1 Assembling the Base Frame - Fig.15,16,17
Turn the saw body upside down and place it on the floor.
Use the Washers (c) and the Hex Screws (a) to fasten the four Legs (29) loosely to the saw body.
Now use the Hex Screws (a), the Washers (c) and the Nuts (d) to fasten the Side Rails (31) and the
Cross Rails (30) loosely to the legs (29).
Please note: The Side Rails are longer than the Cross Rails.
Finally, tighten all screws and nuts on the base frame.
Screw the Leg Braces (A) to the rear legs (29) so that they point towards the rear of the machine - Fig.
17.
Plug the Rubber Feet (13) onto the Legs (29).