Proper Usage; General Safety Instructions - MAKO TOOLS SROM 1197 Instruction Manual

3. PROPER USE:
This machine is designed for ripping and crosscutting wood and plastic in sizes corresponding to the
machine size. It is not suitable for cutting firewood or round-wood.
Use only saw blades which are suitable for the machine. Do not use cutting discs.
The manufacturer assumes no liability whatsoever for improper use, or if the machine has been
tampered with.
Give equal attention to the safety instructions, assembly and operating instructions, as well as all
prevailing accident prevention regulations. Even when the equipment is used as prescribed it is still
impossible to eliminate certain residual risk factors.
The following hazards may arise in connection with the machine's construction and design:
•
Contact with the saw blade in the uncovered saw zone.
•
Reaching into the running saw blade (cut injuries).
•
Kick-back of workpieces and parts of workpieces.
•
Saw blade fracturing.
•
Catapulting of faulty carbide tips from the saw blade.
•
Damage to hearing if essential ear-muffs are not used.
•
Harmful emissions of wood dust when used in closed rooms.
4.

GENERAL SAFETY INSTRUCTIONS:

•
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
Keep your work area clean and well lit to prevent accidents.
•
Don't use electric devices close to flammable liquids or gases, or in wet or damp environments. If
you fail to observe this, there is danger of fire or explosion.
•
Never leave the device running unattended.
•
Never use the device when you are tired or lack concentration or if your reactions are impaired due
to consumption of alcohol or medication. Lack of attention can lead to serious injury.
•
Keep the tools clean and in good working order in order to be able to work better and safer.
•
Don't wear bulky clothing or jewellery.
•
Make sure you can stand stably and have shoes that won't slip.
•
Use a head cover if you have long hair. Loose clothing, jewellery, and long hair can become
entangled in moving parts.
•
Always wear safety goggles.
•
Wear a dust mask when working with materials that produce dust.
•
Wear ear protection if a lot of noise is produced.
•
Persons using the machines must not be distracted. This could cause one to lose control over the
tool.
•
Don't use any device that has a faulty on/off switch. An electric tool that can no longer be switched
on or off is dangerous and must be repaired.
•
Always switch the device on before coming into contact with the material.
•
Remove keys and adjusting tools before switching on the device.