Table of Contents
Advertisement
Mount the Sonic Anemometer
Once you have determined the best location, mount your sensor. The Sonic
Anemometer comes with a mounting bracket that allows you to mount it either
on a pole or on a vertical surface, such as a post or wall.
On a pole, tripod or mast:
Use the included U-bolts and mounting
brackets to mount the sensor on a pole
with a diameter of 1.4 to 1.9 inches (35
mm - 48 mm).
1. Place the U-bolt around the pole and
slide the brackets over the threaded
ends with the flat part of the bracket
facing outward.
2. Slide the U-blot ends through the
anemometer's square base and
loosely install the hex nuts and bolts
with a 10 mm wrench.
3. When the anemometer is in the
desired place on the pole, tighten the nuts.
On a vertical surface:
Use M6 or 1/4" lag screws (not
included) to mount the sensor to a
vertical wooden surface such as a post
or wall.
4
Advertisement
Table of Contents
