Epson DX5 X 2 Calibration And Maintenance page 13

Adjust method:
A. Loosen the 3 screws on the carriage plate:
Note: Note: Note: Every Note: Every Every Every time time time time after after after after the
3 3 3 3 screws screws on screws screws on on the on the the carriage the carriage carriage carriage plate.
pass. pass. pass. pass.
Moreover, after adjust the printhead vertical alignment, check the space between two printhead (note:
space between two printhead is 1 nozzle):
Case1: two printhead overlap
Case2：two printhead separate
the the adjustment, the adjustment, adjustment, before adjustment, before before print before
plate. plate. plate. Keep Keep Keep adjusting Keep adjusting until adjusting adjusting
B. Turn the screw anti-clockwise:
print another print print another another another vertical vertical vertical vertical calibration, calibration, it it it it is is is is required calibration, calibration,
until until until the the the the second second second pass second pass is is is is perfectly pass pass
13
required required required to to to to fasten
perfectly perfectly aligned perfectly aligned aligned with aligned with the with with
Two
overlap, need to
adjust
Two
separate, have to
adjust
fasten fasten fasten the the the the
the the first the first first first
printhead
printhead