TATA Motors TIAGO Owner's Manual page 140

Rear jacking Location
WARNING
If you do not position the jack cor-
rectly at the appropriate jacking
point of the vehicle, the jack could
tip over with the vehicle raised.
There is a risk of injury. Also jack can
be damaged.
Continue to raise the jack slowly and
smoothly until the tyre clears the ground.
Do not raise the vehicle more than re-
quired.
EMERGENCY AND BREAKDOWN ASSISTANCE
Jacking
Remove wheel nuts with the help of
wheel spanner and take out flat tyre.
NOTE
Do not place wheel nuts in sand or
on a dirty surface. Do not apply oil or
grease on it.
Roll the spare wheel into position and
align the holes in the wheel studs.
Tighten each nut in diagonally opposite
sequence by hand until the wheel is se-
curely seated on the hub.
Lower the jack completely then tighten
the wheel nuts one by one using wheel
spanner.
Press fit the wheel cover back (if fitted).
Restore all the tools and jack at their
respective locations.
Place the flat tyre at spare wheel
location.
NOTE
 Do a check and correct the tyre
pressure and wheel nuts tight-
ness of the changed wheel at
nearest authorised service sta-
tion. Get the flat tyre repaired at
the earliest
 Place the jack only at recom-
mended jacking locations.
129